DIY Fans!

A Poor Man’s No Frills Cooling Fan:

From a Computer Fan, Power Adapter and Some Tape.

Greg Hix & Renee Coles-Hix

Cooling fans are great for controlling the heat in your tank. Whether it be a larger tank or a smaller tank, computer fans can either help keep the temperature down single handedly or compliment other cooling measures such as a chiller.

So, what do you have to buy for this project? Just like the subtitle states…. a computer fan, a 12v power adapter and some electrical tape.

all

Tools you need to buy? Nadda. Nothing. Ziltch. You’ll get by perfectly fine with a sharp kitchen knife.

So let’s get to it……..

 

Let’s start with what type of fan and adapter to buy.

An easy to find 12 volt computer fan. If you buy a few on ebay you can generally get them cheap.

fan2

 

The power adapter needs to be a 12 volt AC/DC power adapter. Again cheaper on ebay.

fan3

 

As you can see the tips do not plug into one another.

Let’s cut the fan tips off.

fan4

fan5

 

SWEET!

 

Followed by the removal of the adapter tips.

fan6

fan7

 

Double Sweet!

 

You can see each of the cords has two wires.

fan8

 

Grab either side with your finger tips and separate them to about 1 to 1-1/2 inch lengths.

fan9

 

Now it’s time to remove the plastic insulation. The best way to do this, with the tools we are using, is to run a sharp knife around the diameter of each strand. Careful not to cut the wire strands beneath. Grab the plastic sheath and pull it off exposing the wire. Don’t worry if a few strands of wire come off with it…. it’s of no consequence.

fan10

 

Come on baby… let’s do the twist.

fan11

 

Okay, not that kind of twist. Grab the tips of the wire and twist them like you would a soda bottle cap so that they look like this….

fan12

 

 

Nice and cleeeean!

Now, which wire of the adapter is to be connected with which wire of the fan? It actually makes a difference if you want the air blowing from the “front” of the fan. Otherwise it will blow out the back. It really won’t make a difference which way it blows, since either way it will be as effective. However, you don’t want a bunch of fans that run in all directions…. it adds to confusion. Just imagine if you permanently attached a fan to the hood to find it is blowing in an unexpected direction.

So you line up the adapter wire that has the white lines on it with the red wire of the fan.

See the line (which actually looks like dots on the wire). Please note the wire connections at this point are temporary just to make it easier to see who is connected to what. I will show you a simple way to twist the wires together in a moment.

fan13

 

 

Let’s look a little closer.

fan14

 

 

Run the cords together with the wire together at the top… back-to-back I guess you could say.

fan15

 

 

Then twist the wire together.

fan16

 

 

Then “re-open” the wires.

fan17

 

 

Now pull out that electrical tape.

Wrap the wire connection all the way around so that there is no exposed wire. The two sets of wire CANNOT touch.

fan18

 

 

Continue to wrap the entire cord with tape.

fan19

 

And then……

Oh wait!! And then nothing….

YOU ARE DONE!!

fan20

 

If these fans are to be used on a permanent basis, it’s probably best to invest in some shrink tubing to ensure water cannot get in at the wire connection. Safety first!

STAY COOL THIS SUMMER!
2017-02-09T09:03:46+00:00